All wall and window wall installations must provide for proper drainage.
Ptac wall sleeve installation instructions.
For new installs ensure the wall is properly framed to support the weight and dimensions of the wall sleeve and air conditioner.
The air conditioner will slide into the sleeve but is not flush with the wall.
Wall sleeve installation 920 087 04 8 05 wall sleeve installation instructions pdxws note.
To ensure proper airflow and filter removal it is recom mended installation of the wall sleeve be a minimum of 36 from the ceiling.
The wall sleeve be installed a minimum of 36 from the ceiling.
There is a portion of the air conditioner which extends a few inches back into the room.
All wall and window wall installations must provide for proper drainage.
Failure to install and maintain our product according to these instructions may void any product warranty.
Page 3 pre installation considerations before proceeding with the sleeve installation ensure the following guidelines for locating the wall opening and sleeve are met.
16 24 28 and 31 deep cases are available for thicker walls.
The wall sleeve must be fastened securely before installing the air conditioner unit.
When you visit any website it may store or retrieve information on your browser mostly in the form of cookies.
In applications where the drain holes on the ptac wall sleeve are not exposed beyond the wall an internal drain system is recommended.
Figure 4 minimum interior and exterior note.
Inches mm inches mm inches mm wall sleeve only 3 75 0 0 0 0 subbase kit 3 75 3 1 4 85 2 3 4 70.
If the sleeve projects more than 8 into the room a sub base or other means of support must be used.
While the dimensions may appear to be incompatible the 2 devices should fit properly.
For sunrooms and modular buildings adhere to their installation instructions for supporting and sealing sleeve to their frames.
Prepare and install the new wall sleeve according to the instructions below.
The sleeve will fit flush in the wall extending outside the structure.
See the drain kit for internal actual installation instructions.
Tools required by.
Wall case must be sealed caulked to outside wall on all four 4 sides.
Wall case should be sealed caulked to the inside wall on all four 4 sides.
This information might be about you your preferences or your device and is mostly used to make the site work as you expect it to.
Consult a licensed contractor as needed.
Installation guidelines for sealing ptac sleeves read these instructions completely before starting any installation.
Insure that the unit is only installed in a wall structurally adequate to support the unit including the sleeve chassis and accessories.
Standard steel wall cases are 42 w 16 h 13 3 4 d.
